HEA section
HEA sections are light-series wide flange H beams, used for columns and beams in industrial halls, platforms and pipe racks.
24 sizesHEB section
HEB sections are standard-series wide flange H beams, thicker than HEA, for loaded columns and beams.
24 sizesHEM section
HEM sections are the heavy series of H beams, with very thick flanges and web, for high loads.
24 sizesIPE section
IPE sections are parallel flange I beams, the most common choice for floor beams, purlins and light structures.
18 sizesINP section
INP (IPN) sections are taper flange I beams, the classic type, still often requested for repairs and crane runways.
23 sizesUPN section
UPN (UNP) sections are taper flange channels, used for frames, chassis, stairs and secondary structures.
18 sizesUPE section
UPE sections are parallel flange channels, easier to bolt than UPN.
14 sizesRound tube
Round steel tubes are used for installations, structures, fences, railings and light steel buildings.
224 sizesSquare tube
Square tube (square hollow section) is used for gates, fences, structures, metal furniture and frames.
159 sizesRectangular tube
Rectangular tube (rectangular hollow section) is preferred for light beams, frames, gates and structures where stiffness in one direction matters.
208 sizesSteel sheet
Black, pickled, galvanized or heavy steel sheet and plate, from 0.4 to 100 mm thick, in standard sizes.
27 sizesRound bar
Hot-rolled or drawn round bars are used for shafts, pins, tie rods and turned parts.
33 sizesSquare bar
Solid square bars are used for ironwork, wrought gates, grilles and mechanical parts.
18 sizesHexagon bar
Hexagon bars are used for nuts, studs and turned parts with wrench flats.
18 sizesFlat bar
Flat bar is used for base plates, stiffeners, ironwork, earthing and fabrication.
142 sizesEqual angle
The equal leg angle (L section) is one of the most used sections in steel fabrication, frames and bracing.
35 sizesUnequal angle
The unequal leg angle is used where one leg must be longer, for example on brackets and frames.
19 sizesT section
Equal T sections are used for window frames, sills, supports and fabrication.
13 sizesRebar
Rebar (B500, BST500S) is used to reinforce concrete. It is usually sold in 12 m bars or coils.
14 sizes